DBI/SALA Nets 

Adjust-A-Net™ is an infinitely adjustable fall protection and debris containment net system.

Adjust-A-Net's™ easily adjustable straps allow you to make it as large or as small as needed, 15 ft. x 25 ft. max size (others available, see below)
Reduce sag with quick-adjust buckle releases.
3-1/2" mesh which is the smallest in the industry for better protection.
A specially developed coating protects from the damaging effects of UV light, resists abrasion and securely bonds all convergent points.
Inspection-ready test cords serve as a built in indicator and allow for the evaluation of
Adjust-A-Net's™ structural integritiy.
Rugged steel snap hooks are placed every 48 inches. Staggered spacing on opposite sides allows any size.
Adjust-A-Net™ to be easily connected together Adjust-A-Net™ is available with an attached debris liner for added workplace safety.
Adjust-A-Net's™ long wearing, high-tenacity nylon has been tested to withstand a force greater than 17,500 foot-pounds and complies
with ANSI and OSHA regulations. 

 DBI/SALA Nets 

Our Vertical Netting is the most cost-effective debris containment and guardrail system on the market.

Vertical Net protects workers near building edges by serving as a guardrail.
48" high x 100 ft. long with 50 EZ clips and 20 tie-down plates (other sizes available, see below).
Increases public safety by preventing falling debris Eliminates the need for a separate mid-rail and toe-board.
Easy to install, remove, relocate and store.
Exceeds strength requirements of OSHA's 200 pound lateral force test.
High visible so you know it is in place even from the ground level.
Also useful as temporary partitions for crowd control or demolition.
System comes complete with everything needed, vertical netting, zip clips for easy and secure net installation and tie-down plates to replace toe-boards and firmly set the net into place.